Home
Forward|
Home |
Forward |
PAGE 3
7/12/03
These are the center and rear floor supports.
The center support is the original, I patched it up and used POR-15 on the inside. I had to weld new 3/8 inch nuts in for the body mount locations.
The rear support and the short support are new ones form Ralph, very, very high quality.
I just have them laying in place for alignment right now.
This is what's left of the old floor next to the new one before trimming the new one to fit.
The old one has alot of history! The stories it could tell.
Now I finally feel like I doing something!!!
This is obviously the drivers floor pan, I just have it laid in place to check for fit. When can I fire up the welder!!!????
Not yet....
The drivers side rear, I have used some very expensive alignment tools to make sure it's true with the frame.
Now it all has to come apart AGAIN for final trimming and sealing the inside of the new supports.
I couldn't resist mocking up everything to see how it looked.
It's gonna be so cool,
SOMEDAY!
Before After
Go to page1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48
