PAGE 7
 

Latest update HERE 

 

Front end disassembly and fender repair.


June-July 2019


Moving to the front sheet metal.

There is rust in the rear sections of both front fenders, the inner fenders also need to be replaced because of damage.

   



I won't bore you with the tedium of disassembly of the front end, the time lapse video below shows it all.










   




   


Doesn't look to bad on the drivers fender.






  After cleaning it up it is worse than expected but definitely repairable.

These fenders are not yet reproduced and finding nice replacements are getting harder to find.




  Time to check out the passenger fender.  There are some visual clues that the lower rear has an excessive amount of filler in it.




   


This isn't looking good.  It seems looks like the same "body man" that "repaired" the rear quarter panel has been at it again.


   



It's pretty bad.






  At this point I'm going to try and find a original fender in better condition than what I've got to work with here. 

It's all just completely rotted away.

If you've got a 71-72 passenger fender let me know!






   

Back to the driver fender.

I marked the area I want to remove, I left a healthy margin into known good solid metal.




 
   


All the rot on the outside is removed.

Note I left the rearmost edge of the fender, I have found its much easier to maintain the proper contour of the trailing edge by leaving the original.



   

This is looking at the back side of the fender.  What you are seeing is a heavy brace the runs from top to bottom of the rear of the fender.

There is some pretty severe rot here as well.  It's been sandblasted and marked for cutting.





   


That's one helluva hole!

The picture on the right is after I sand blasted as far up inside the brace as I could get and painted the area to protect it from further rust.



   


I used the removed section to make a template and then transferred that to a piece of new metal.

I spent some time getting the curvature of the piece to match the original curve of the fender.

Working slowly until it fits perfectly.





   


The piece is slowly tacked into place, another small piece is made and fitted to the rest of the opening.





   


Slowly the tack welds are joined together being careful not to generate too much heat in any one area.

The welds are then ground down.  The small sharpy circles indicate pin holes that need to be welded.



   

There is a small rusted out area on the bottom of the fender.  I cut this out...




   


...and the area under it was cleaned out, sandblasted and painted.

Then a small piece was cut to fit the area.




   


Welded in place and ground smooth.  Nothing to see here anymore!




   


Moving to the inside brace, I needed to hand fabricate the parts to repair the brace. 

The main piece is then welded into place.





   


The rest of the replacement pieces are made and welded into place.




   


I then sandblasted the area again and painted it with a protective coat.

Just as strong as new!





 



Only a very thin layer of body filler was required to bring the area back into a perfectly smooth and properly curved condition


There were a couple very small areas that needed a little filler as well.


The rest of the fender was scuffed and cleaned thoroughly.



   









   

After a couple coats of epoxy primer, it's always really cool to see a panel all in one color.

 


Within 72 hours I applied 4 heavy coats of high build primer.  This will allow me to get this panel laser straight.  





Much more bodywork to come, finally some reassembly and color soon!


  Lots more to see... Next Page 8

Other Projects @
57RUSTBUCKET.COM
Page

1 2 3 4 5 6 7 8 9 10 11 12
Contact Us!
John@57rustbucket.com
                            
 
 

 

Follow us on Facebook